Constant Speed Agitator, Chuck Holding Size φ1.5 ~10mm, 250W (CAT#: STEM-GLE-0630-LGH)

1. After the stirring rod is clamped, it must be rotated by hand to see if the concentricity is not good, and the re-clamp should be loosened, and then turn on the power and gradually accelerate from slow to fast.
2. If the stirring rod itself can be guided, a piece of rubber tube can be used to connect the stirring rod and the motor shaft flexibly, and the torque can be transmitted.
3. The temperature rise of the motor casing is allowed to be 45℃, that is, the temperature of the casing in summer is not more than 75℃, which is normal. If the temperature of the motor exceeds 45°C, most of the reasons are caused by overloading. Reducing the blades of the stirring rod and increasing the rotation speed can reduce the temperature rise. (The temperature of the motor rises at medium speed)
4. The motor is overheated, most of which are caused by the heavy load. Please pay attention to the rotation diameter of the stirring rod blades. 40W: 4-6cm 60W: 4-6cm 90W: 6-9cm When the viscosity of the liquid is high, the fins are appropriately reduced.

Power supply: AC220V 50 ~ 60 Hz (single phase)
Rotational speed range: 60~1400
Chuck holding size: φ 1.5~13 mm
Net weight (kg) : 10.8

If the stirring rod itself can be guided, a piece of rubber tube can be used to connect the stirring rod and the motor shaft flexibly, and the torque can be transmitted.
The temperature rise of the motor casing is allowed to be 45℃, that is, the temperature of the casing in summer is not more than 75℃, which is normal. If the temperature of the motor exceeds 45°C, most of the reasons are caused by overloading. Reducing the blades of the stirring rod and increasing the rotation speed can reduce the temperature rise. (The temperature of the motor rises at medium speed)