MJ-Ⅲ Mold Incubator Series, 150L, 800W, ShangHai CIMO Medical Instrument co.,Ltd. (CAT#: STEM-CC-0211-YJL)

YQX-Ⅱ Anaerobic Incubator, +3-84℃, model YQX-Ⅱ, is manufactured by ShangHai CIMO Medical Instrument co.,Ltd. This product is a high-precision equipment with cold and hot constant temperature and constant humidity control.

Volume: 150L
Heating/cooling method: stainless steel electric heater/fully enclosed fluorine-free compressor
Temperature control range: 0℃-60℃/When humidifying10℃-45℃
Temperature resolution: 0.1℃
Temperature fluctuation: ±0.5℃(heating operation state)/±1℃(cooling operation state)
Humidity control range: 50-95% humidity control fluctuation ±5%RH(25℃~40℃)
Humidification method: External ultrasonic humidifier
Number of Shelves: 3
Refrigerant:: R134a(fluorine-free environmental protection type)
Working time: 1-9999 h or continuous
Power: 800W
Power supply: AC 220V 50Hz
Studio sizemm: 480*390*780
Dimensionmm: 610*625*1435

The inner tank is made of high-quality mirror stainless steel material, which has the characteristics of corrosion resistance, acid resistance, easy cleaning, and never rust.
Microcomputer intelligent temperature controller, P.I.D. control, stable temperature control, high precision, LED high-brightness digital display, intuitive and clear, with good control ability and anti-interference ability. You can choose continuous working mode or timing working mode; it has the function of compressor overheating protection.
Double temperature insurance device: The temperature controller has automatic tracking and over-temperature alarm device; once the temperature is too high, the heating system is immediately cut off, and a temperature insurance device is installed in the working room to ensure the safety of the culture in the working room.
Optional programming control mode, can set a variety of parameters (including temperature, humidity, time, etc.) to run (optional).
Independent temperature limit alarm system, automatically interrupts immediately when the temperature exceeds the limit to ensure the smooth progress of the experiment (optional).
Double-layer door structure: After the outer door is opened, the experimental conditions of the studio are observed through the inner door made of high-strength tempered glass, and the temperature and humidity are not affected. The working room is equipped with ultraviolet sterilization device.
There is a test hole on the right side of the box, which is convenient for experimental operation and temperature measurement (optional).
The studio shelf is made of stainless steel, and the height of the shelf can be adjusted at will. Timing time up to 9999 hours.
It can be equipped with a printer or RS-485 interface, which can be connected to a computer to record changes in parameters such as temperature and humidity (optional).

Mold Incubator BPMJ (CAT#: STEM-CC-0028-YJL)
Mold Incubator BPMJ (CAT#: STEM-CC-0029-YJL)
MJ-Ⅱ Mold Incubator Series (CAT#: STEM-CC-0222-YJL)
MJ-Ⅱ Mold Incubator Series (CAT#: STEM-CC-0223-YJL)
Mold Incubator MJ (CAT#: STEM-CC-0014-YJL)
Mold Incubator MJ (CAT#: STEM-CC-0015-YJL)