Shanghai Jingqi COD Reflux Digester HCA-106B (Glass-Ceramic), Shanghai Jingqi Instrument Co., Ltd. (CAT#: STEM-GLE-2185-YJL)

Shanghai Jingqi COD Reflux Digester HCA-106B (Glass-Ceramic), model HCA-106B is manufactured by Shanghai Jingqi Instrument Co., Ltd.
The national standard GB11914-89 analysis method standardizes the determination steps of COD (cr) of water quality, and strictly stipulates the heating and digestion time of the method, the acidity of the solution, the amount of oxidant and catalyst and other condition indicators. Obviously, the determination of water quality COD (cr) has strict conditions and regulations, and the operation in violation of the conditions and regulations will affect the accuracy of the determination.
HCA-106B constant temperature digester adopts domestic advanced embedded black crystal heating glass as the assembly part of its heating system, so as to achieve real acid and alkali resistance and corrosion resistance. Black crystal heating glass has the advantages of fast heating up, high utilization rate of heat energy, balanced heating of each area on the surface, and fast cooling speed after heating stops. HCA-106B standard COD digester uses glass burr return pipe instead of spherical return pipe, and uses air cooling technology to replace tap water return cooling method, and uses still water to assist cooling at the end of the condensation pipe. It can not only save water, but also standardize the instrument, and also improve the safety of the instrument. HCA-106B standard COD digester adopts microcomputer technology to carry out timing control heating electric furnace, which can heat eight 250ML conical digestion and reflux devices at the same time. To achieve the purpose of saving energy, reducing power load and increasing GX rate.
HCA-106B standard COD digester follows the basic principles of international standards (ISO) and national standards (GB11914-89), ensuring the digestion operation of reflux heating and slight boiling for 2 hours. The preparation and addition of the reagent solution are consistent with the national standard method to ensure reliable JQ analysis results.
The chemical solution preparation, operation and COD calculation of the instrument fully comply with GB11914-89. For COD water samples lower than 50mg/L, the JQ degree can be increased by diluting the titrant and oxidant, and for COD water samples higher than 700mg/L, the measurement can be completed by proportional dilution of the water samples.

Measuring range: 0~1000mg/L, 0-10000 water sample diluted and measured
Digestion time: 10 minutes - 2 hours and 30 minutes (users can choose the heating time independently)
Measurement error: Potassium hydrogen phthalate standard solution (500mg/L), relative standard deviation is not more than 5.0%
Ambient temperature: ≤35℃
Number of digestion samples: 6 (250mL conical flask with 24# ground mouth) 12 (150mL conical flask with 24# ground mouth)
Heating power: ≤1600W (AC 220V, 50HZ, the user can choose the heating power independently)
Instrument size: 45cm (L) * 35cm (W) * 65cm (H)

The wavy ribbon-shaped heating wire of the flat electric hob is a new type of rare earth alloy material, and its service life is extremely long. The surface of the electric hob is covered with a glass panel that can withstand high temperatures of 800°C. When heating, the surface of the electric hob heats up evenly, and the heating and cooling speed is fast.
The electric hob uses a new type of high-temperature resistant inorganic environmental protection heat insulation material, the heat loss of the bottom plate and the surrounding area is small, the heat reception and heat conduction are uniform, and the thermal efficiency is higher.
The high-temperature-resistant glass panel of the flat-panel electric hob is flat, smooth, and easy to clean; if the surface is stained, just wipe it dry with a cloth, which can reduce damage to the instrument due to improper operation.
Improved glass burr reflux tube and heat dissipation system, its good digestion reflux effect ensures the parallelism and accuracy of sample digestion results.
Corresponding to different heating powers selected by the user, the surface heating temperature of the electric furnace can be displayed.
The digestion time can be set. After the digestion is completed, the instrument will automatically stop heating, and the instrument fan will continue to work for half an hour to assist the cooling of the sample, which can be left unattended.
Energy-saving, water-saving, safe and reliable, improve the work efficiency of operators.

Shanghai Jingqi Multifunctional CNC Digester (12 holes) DR-12 (CAT#: STEM-GLE-2121-YJL)
Shanghai Jingqi Intelligent Graphite Digester DRG-30 (CAT#: STEM-GLE-2177-YJL)
Shanghai Jingqi Intelligent Graphite Digester DRG-48 (CAT#: STEM-GLE-2178-YJL)
Shanghai Jingqi Intelligent Graphite Digester DRG-36 (CAT#: STEM-GLE-2179-YJL)
Shanghai Jingqi Intelligent Graphite Digester DRG-20 (CAT#: STEM-GLE-2180-YJL)
Shanghai Jingqi Intelligent Graphite Digester DRG-6 (CAT#: STEM-GLE-2181-YJL)