MJ-Ⅱ Mold Incubator Series, 250L, 500W, ShangHai CIMO Medical Instrument co.,Ltd. (CAT#: STEM-CC-0224-YJL)

YQX-Ⅱ Anaerobic Incubator, +3-97℃, model YQX-Ⅱ, is manufactured by ShangHai CIMO Medical Instrument co.,Ltd. The inner tank of this product is made of high-quality mirror stainless steel, which has the characteristics of corrosion resistance, acid resistance, easy cleaning, and never rust. It adopts microcomputer intelligent temperature controller and P.I.D. control, which makes the temperature control stable and precise. 7-digit LED high-brightness digital display, intuitive and clear, with good control ability and anti-interference ability.

Volume: 250L
Heating/cooling method: stainless steel electric heater/fully enclosed fluorine-free compressor
Temperature control range: 0℃~60℃
Temperature resolution: 0.1℃
Temperature fluctuation: ±0.5℃(heating operation state)/±1℃(cooling operation state)
Number of Shelves: 3
Refrigerant:: R134a(fluorine-free environmental protection type)
Working time: 1min-99h min or continuous
Power: 500W
Power supply: AC 220V 50Hz
Studio sizemm: 570*500*850
Dimensionmm: 700*715*1500

Double temperature insurance device: The temperature controller has automatic tracking and over-temperature alarm device; once the temperature is too high, the heating system is immediately cut off, and a temperature insurance device is installed in the working room to ensure the safety of the culture in the working room.
Independent temperature limit alarm system, automatically interrupts immediately when the temperature exceeds the limit to ensure the smooth progress of the experiment (optional).
It can be equipped with a printer or RS-485 interface, which can be connected to a computer to record the changes of test parameters (optional).
Double-layer door structure: After the outer door is opened, the experimental conditions of the studio are observed through the inner door made of high-strength tempered glass, and the temperature is not affected.
The working room is equipped with ultraviolet sterilization device lamp; BOD socket (limited to 150L and above); the height of the shelf in the working room can be adjusted at will.
Working time setting range: 1 minute - 99 hours and 59 minutes.

Mold Incubator BPMJ (CAT#: STEM-CC-0028-YJL)
Mold Incubator BPMJ (CAT#: STEM-CC-0029-YJL)
MJ-Ⅲ Mold Incubator Series (CAT#: STEM-CC-0211-YJL)
MJ-Ⅲ Mold Incubator Series (CAT#: STEM-CC-0212-YJL)
Mold Incubator MJ (CAT#: STEM-CC-0014-YJL)
Mold Incubator MJ (CAT#: STEM-CC-0015-YJL)