Nano LC-2D System, AB MDS Sciex (CAT#: STEM-CPO-0594-ZJF)

The manufacturer of the Nano LC-2D System, AB MDS Sciex is AB MDS Sciex.
Refurbished Applied Biosystems 2D Nano LC system consisting of AB MDS Sciex tempo Nano MDLC pump (Powered by Eksigent m/n Nano LC-2D) & ABI MDS Sciex 920 autosampler with cooling module. Sold as part of the 4000 Q TRAP system or as a stand-alone Nano LC system.

Condition: Refurbished, Certified Pre-owned
Flow Rate Range:
First dimension: 1-20 µL/min
Second dimension: 20-1000 nL/min
Pump Type: Microfluidic direct pumping system with independent flow control feedback for each mobile phase Retention time RSD < 0.5% at 500 nL/min.
Gradient Formation: High-pressure gradient mixing; no flow splitting
Delay Volume:
First dimension: 300 nL from mixer to column
Low-flow dimension: 65 nL from mixer to column
Delay Time: < 25 sec at 500 nL/min
Mobile Phase Compatibility: All mobile phases compatible with 316 stainless steel, PEEK, and silica
Injections: Standard, metered and rapid injection modes
Injection Volume: 200-50 µL; option for larger sample volumes available
Columns:
First dimension: optimized for use with 300-500 µm i.d. traps or columns (5 cm)
Second dimension: 50-150 µm i.d. columns, 5-15 cm in length
Peak Parking: Response time from 500-100 nL/min typically < 4 seconds at spray tip. Response time can vary with external hardware configuration.
Autosampler: One 96- or 384-well plate capacity Peltier type temperature maintained sample compartment. 5-40° C; cooling capacity 12° C below ambient Dual needle design for seal piercing Integral 6-port biocompatible injection valve.
Power Requirements: 100-240 VAC, 4/63 Hz, 3A
Dimensions:
Width: 18 inches (46 cm)
Depth: 22 inches (56 cm)
Height: 8 inches (20 cm)
Optional: VICI valve & two position actuator control module (p/n EHCA-CE)

Optimized for ultra-low flow rates of first dimension 1-20 µL/min, second dimension 50-1000 nL/min.
Novel pumping system eliminates the need for flow splitting, providing excellent run-to-run reproducibility.
Use automated peak parking for extended MS/MS analysis to improve peptide sequence coverage.
Take advantage of nanospray sensitivity.
Active flow control of each mobile phase ensures precise gradient delivery.
Quickly responds to changes in flow rate set point in less than two seconds.
Reduce solvent consumption by 99%

Nano LC-1D System, Eksigent
NanoAcquity Flow Control Module, Waters
GPIB-SCSI-A IEEE-488 to SCSI Controller, National Instruments