ProDIGITAL ODO/T Cable Assembly, 20 m, YSI, accessory for the ProSolo, ProSwap, and ProDSS handhelds (CAT#: STEM-AIAE-0206-ZJF)

The ProDIGITAL ODO/T Cable Assembly manufactured by YSI is a probe and cable assembly with integral optical dissolved oxygen and temperature sensors for the ProSolo, ProSwap, and ProDSS handhelds.
Pre-assembled ProSolo ODO/T kits are available.
With integral digital sensors, the ODO/T is plug-and-play, thereby minimizing setup time. Due to the ProDIGITAL technology, the handheld can automatically recognize connected sensors, so there is no need to tell the instrument what sensors are connected.
As a non-consumptive technology, optical dissolving oxygen (ODO) does not consume oxygen during measurement. There is no flow dependence and no stirring is required, resulting in the most accurate DO measurements available from a probe. ODO sensors are not susceptible to interference from other gases, drift less, and maintain calibration longer than membrane-covered sensors. With a simple, threaded optical cap that is guaranteed for at least two years, maintenance is a breeze.
It is an accessory for the following products:
ProDSS Multiparameter Meter
ProSolo Optical Dissolved Oxygen and Conductivity Meter
ProSwap Digital Water Quality Meter

SKU: 627200-20
Accuracy: Temperature - ±0.2 °C; Dissolved Oxygen - 0 to 200%: ±1% of reading or 1% saturation, whichever is greater; 200 to 500%: ±8% of reading 0 to 20 mg/L: ±0.1 mg/L or 1% of reading, whichever is greater; 20 to 50 mg/L: ±8% of reading
Measurement Method / Channels: Temperature - Thermistor; Dissolved Oxygen - Optical luminescence - lifetime method
Measurement Range: Temperature - -5 to 70 °C (temperature compensation range for DO mg/L measurement: -5 to 50 °C ); Dissolved Oxygen - 0 to 500%, 0 to 50 mg/L
Parameters Measured: Dissolved Oxygen, Temperature
Size: Width - 2.46 cm (0.97 in.)
Unit of Measure: Temperature - °C, °F, K; Dissolved Oxygen - % saturation, % saturation local, mg/L, ppm
Warranty: Warranty 2-year probe and cable assembly; 2-year extended warranty ODO sensor cap

Automatically recognized integral optical DO and temperature sensors reduce instrument set-up time.
New assemblies are pre-installed with rugged optical DO sensor caps with a 2-year warranty.
Weighted stainless steel probe guard and Military Specification (MS) connector
Fits in a 1-inch well
Cable Length: 20 m (available up to 100 m)
Warranty of two years on cable, sensors, and ODO cap

ProDSS Multiparameter Meter, No GPS, YSI
ProDSS Multiparameter Meter, With GPS, YSI
ProQuatro Multiparameter Meter, YSI
ProSolo Optical Dissolved Oxygen and Conductivity Meter, YSI
ProSwap Digital Water Quality Meter, No GPS, YSI
ProSwap Digital Water Quality Meter, With GPS, YSI