Unlock Exclusive Discounts & Flash Sales! Click Here to Join the Deals on Every Wednesday!

Rapid Identification of Intact Whole Bacteria Based on Spectral Patterns using Matrix-assisted Laser Desorption/Ionization with Time-of-flight Mass Spectrometry (CAT#: STEM-ST-0304-LJX)

Introduction

Matrix assisted laser desorption/ionization time-of-flight mass spectrometry (MALDI-TOFMS) was investigated as a method for the rapid identification of whole bacteria, either by comparison with archived reference spectra or by co-analysis with cultures of known bacteria. Bacteria were sampled from colonies on an agar plate, mixed with the matrix, air-dried, and introduced in batches into the mass spectrometer for analysis. In the first experiment, both bacterial strains that had been previously analyzed to obtain reference spectra and other strains that had not been analyzed were blind-numbered and their spectra were obtained. Those strains that matched reference spectra were found to be correctly identified. A second experiment involved co-analysis of reference strains and bind-numbered strains under identical conditions; species-specific identification was demonstrated by comparison of spectra of the blind-numbered strains with those of the standards. In all of the spectra obtained in these experiments, each bacterial strain showed a few characteristic high-mass ions which are thought to be derived from bacterial proteins. This work represents the first reported instance of successful bacterial chemotaxonomy by MALDI-TOFMS analysis of whole cells. For the strains tested, the method is rapid and simple.




Principle

In a very small area and a very short time interval (ns order of magnitude), the laser delivers high-intensity pulse energy to the sample under test, causing it to desorption and ionize instantaneously without thermal decomposition. MALDI is a mass spectrometry ionization method for direct evaporation and ionization of non-volatile samples.

Applications

For measuring the molecular weight of biological macromolecules, such as the molecular weight distribution of peptides, proteins, nucleic acids, polymers and oligomer analysis.

Procedure

1. Mix the sample with the appropriate matrix material and load it onto the metal plate.
2. Pulsed laser light is used to irradiate the sample and trigger ablation and desorption of the sample and matrix materials.
3. Analyte molecules are ionized by protonation or deprotonation in the thermal plume of the ablated gas and are then accelerated to a mass analyzer for analysis.

Materials

• Sample Type:
Bacteria

Notes

1. During shutdown, if the nitrogen is not turned off, the pressure should be properly lowered to avoid moisture.
2. Keep an eye on instrument drift during manual measurement. If there is drift, the instrument needs to be calibrated with standard peptide or standard protein.
Advertisement