Waters e2695 Separations Module with 2998 Photodiode Array and 2414 Refractive Index Detectors, 100-240 VOLTS, Waters (CAT#: STEM-LAPO-0250-LJX)

The 2489 UV/Vis Detector is a very sensitive and versatile dual-wavelength absorbance detector for HPLC and UHPLC. It is designed to combine high-energy deuterium lamps, sophisticated optical design, and low-noise, high-speed electronics in the same detector. All of these advanced innovations take UV/Vis inspection performance to a whole new level.
Identification and quantification of major and minor components was done in the same run with a linear range of 2.5 AU
Monitor absorbance at two user-selected wavelengths to gain more analyte information and increase productivity with each run
With the information provided by tracking the serial number, age of the lamp and number of lights on, the confidence level helps maintain optimal system utilization

Condition: Used
CE Marked: YES
Type of Detector for HPLC: REFRACTIVE INDEX
Second Detector: PHOTODIODE ARRAY
Type of Pump for HPLC: QUATERNARY
Voltage: 100-240 VOLTS
Frequency: 50/60 HERTZ
Recommended Packaging Form: CUSTOM PALLET
Dimensions: Standard
Overall: 27 x 25 x 39 IN - 178 LBS

The proprietary TaperSlit flow cell allows light to pass through the flow cell under guidance to obtain higher energy flux while minimizing the influence of RI to improve sensitivity
Low noise (<5 μAU)
Optimize the signal-to-noise ratio performance of the lamp as much as possible over the entire service life of the deuterium lamp
The acquisition rate is flexible and variable, covering 1~80 Hz, and normal and fast LC separation is applicable
The acquisition rate and filter time constants can be optimized independently, allowing you to adjust the detector to the separation target
Enhanced thermal drift management reduces baseline drift caused by fluctuations caused by environmental conditions
Multiple flow cell options are available to flexibly match your separation size and type
Easy-to-access detector assembly for easy handling and maintenance

Leistritz Nano 16 Twin-Screw Extruder, 250 RPM, Leistritz (CAT#-STEM-LAPO-0257-LJX)
Olympus BX51TRF Binocular Microscope, 100-120/220-240 VOLTS, Olympus (CAT#-STEM-LAPO-0252-LJX)
Unused Mettler Toledo HX204 Moisture Analyzer, 220/230 VOLTS, Mettler Toledo (CAT#-STEM-LAPO-0253-LJX)
Three Tec ZE5/9 Twin Screw Mini Extruder With Three Tec ZD5 FB-C1M-DN50 Double Screw Feeder, 230 VOLTS, Three Tec GmbH (CAT#-STEM-LAPO-0254-LJX)
Thermo Prism Pharmalab 16 Hot Melt Twin-Screw Extruder, 10 AMPS, Thermo Fisher Scientific (CAT#-STEM-LAPO-0255-LJX)
Huttlin Mycrolab Multifunctional Fluid Bed Dryer, 0.53 gal, Huttlin (CAT#-STEM-LAPO-0256-LJX)