Agilent 1100 Series - G1364D HPLC Fraction Collector, Agilent Technologies (CAT#: STEM-C-0049-LGZ)

The manufacturer of Agilent 1100 Series - G1364D HPLC Fraction Collector is Agilent Technologies. Model is 1100 Series - G1364D. It is used for preparation-scale applications as part of the Agilent 1100 HPLC system.

Condition: used
Trigger Modes: Time slices, Peak (threshold, up- /downslope), Timetable (combination of time intervals and peak) and Manual trigger (supported only with G1323BControl Module)
Operating Modes: Discrete fractions: default mode for all vessels. The flow is diverted to waste, while moving from one vessel position to the next vessel position Continuous flow: optional, available only when using well plates. It is possible to move from one well plate position to the next one without diverting the flow into the well plate to waste
Test tube /plate sizes: Minimum 48 mm to 100 mm maximum
Maximum tube volume: ca. 45 mL
Maximum flow rate: 100 mL / min (depending on viscosity and generated back pressure, max. 6 bar at the diverter valve)
Delay volumes [μL]:
Fraction collector inlet to diverter valve: -500 (typical, depends on length of the tubing)
Diverter valve: ~15
Diverter valve to needle: ~110
Needle: -~5
Delay calibration Sensor: Single wavelength absorbance detector working at 654 nm, consisting of a LED and a photo diode
Diverter Valve: 3/2 Diverter valve with low internal volume (15 μL), switching time < 100 ms, maximum operating pressure 6 bar
Cooling: Optional (with additional G1330B), performance depending on ambient conditions and the volume of collected fractions
Maximum capacity: 3 fraction collectors in parallel plus one recovery fraction collector connected via 12-Position, 13-Port Selector valve
GLP features Early maintenance feedback (EMF), electronic records of maintenance and errors
Interfaces: Controller-area network (CAN). optional; LAN or external contacts interface RS232C, APG-remote (for remote start / stop signals to / from other modules) Interface to G1330A Thermostat CAN-DC-out for operation of Agilent approved external devices like valves
Safety features: Leak detection and safe leak handling, error detection and display, exhaust fan for fume extraction of hazardous vapors

1. The G1364D is a micro fraction collector/ spotter that is part of the Agilent 1100 High Performance Liquid Chromatography system.
2. This item was removed from a manufacturing lab as surplus to requirements. It has applications in laboratories focused on chromatography and mixture separation.
3. It is used for preparation-scale applications as part of a complete HPLC system.

Gilson FC204 HPLC Fraction Collector, Gilson(CAT#-STEM-C-0197-LGZ)
Transgenomic FCW 200 Wave HPLC Fraction Collector, Transgenomic (CAT#-STEM-C-0202-LGZ)
Amersham Biosciences GE FRAC-900 FPLC Fraction Collector, Amersham Biosciences(CAT#-STEM-C-0204-LGZ)
Amersham Pharmacia Biotech Frac-950 FPLC Fraction Collector, Amersham Biosciences Corp.(CAT#-STEM-C-0205-LGZ)
Shimadzu FRC-10A HPLC Fraction Collector, Shimadzu Excellence in Science(CAT#-STEM-C-0206-LGZ)
Honeycomb HPLC Fraction Collector, Bioanalytical Systems, Inc (BASi)(CAT#-STEM-C-0213-LGZ)