Gilson FC204 HPLC Fraction Collector, Gilson (CAT#: STEM-C-0197-LGZ)

The manufacturer of Gilson FC204 HPLC Fraction Collector is Gilson. Model is FC204. The FC 204 fraction collector is a compact, high-capacity fraction collector.

Condition: used
3-way valve: Three-port, PTFE, 67 µL internal volume. 3,5 µL dead volume from the common port to the normally closed port, up to 20 mL/min with large bore needle OR Three-port, PTFE, 114 µL internal volume. 6 µL dead volume from the common port to the normally closed port, up to 200 mL/min with large bore needle.


Contact control


Contact closure inputs for start/advance and end/home
Event mark output
One programmable output for control of peripheral devices
Data acquisition: An input channel for analog-to-digital conversion; digital data is transmitted on the GSIOC
Detector input: ±100 mV full scale
Display: two lines of 24 alphanumeric characters; backlit LCD
Drop counting: Up to 9999 drops per fraction. Maximum rate: 20 drops per second


Environmental conditions


Indoor use only
Up to 2000 meters altitude
5° - 40 °C temperature range
75 - 105 kPa air pressure
Pollution degree 1 or 2 in accordance with IEC 66
Maximum relative humidity 80% for temperatures up to 31°, decreasing linearly to 50% relative humidity at 40 °C.
Event marker: 100 ms pulse (contact closure)
Maximum collection volume/tube: 32 mL (18 x 180 mm tube) or 25 mL (18 x 150 mm tube)
Maximum fractions: up to 768 fractions when configured with eight 96-well, 2 mL Whatman/Plyfiltronics microplates on a Code 17 rack
Multi-cycle operation: repetitive collection of each sample into same set of tubes or collection each sample into different set of tubes
Multiple column collection: simultaneous collection from up to 18 columns with installation of optimal multiple column adapter(s).
Number of racks: One Code 16 or 16D rack, one Code 17 rack, or up to four Code 20-Series racks (all racks must be same code)
Operating modes: Time, drop, peak + time, peak + drop, and manual


Peak detection


Adaptive slope algorithm that applies use-specified parameters to accommodate drifting baselines, negative peaks, and asymmetrical peaks or absolute threshold level that collects all peaks above specified millivolt value
Peak Parameters: peak height or level, in mV, and peak width at half-height, in minutes
Minimum peak height for fractionation: 0.1 mV full scale
Detector-collector delay: 0.01 minute increments
Physical space requirement: 47.9 x 46.4 x 33.0 cm (18.9 x 18.3 x 13.0 in.)


Power requirements


Frequency: 50 to 60 Hz
Voltage: 100 - 120 V or 220 - 240 V, mains voltage fluctuations not to exceed ±10% of the nominal voltage
Current rating: 0.5 A for 100 - 120 V or 0.25 A for 220 - 240 V
Programmable time units (min.): from 0.01 to 99.99 minutes per tube, with 0.01 minute limit of resolution
Software control: Via Gilson Serial Input/Output CHannel (GSIOC) or by contact closure
Time based programming: Up to ten collection windows and ten drain steps in any mode
Tube change time: 100-720 ms. Center-to-center, depending on rack type
Weight: 10.9 kg (24 lbs)

1. Compact.
2. Large capacity, with enough capacity to handle test tubes, bottles and up to 8 shallow or deep microplates.
3. Scores can be collected by drop, peak or time.
4. The collector can use any HPLC system.

Transgenomic FCW 200 Wave HPLC Fraction Collector, Transgenomic (CAT#-STEM-C-0202-LGZ)
Shimadzu FRC-10A HPLC Fraction Collector, Shimadzu Excellence in Science(CAT#-STEM-C-0206-LGZ)
Honeycomb HPLC Fraction Collector, Bioanalytical Systems, Inc (BASi)(CAT#-STEM-C-0213-LGZ)
Pharmacia LKB Frac-100 HPLC Fraction Collector, Pharmacia Fine Chemicals(CAT#-STEM-C-0233-LGZ)