2465 Electrochemical Detector, Waters Corporation (CAT#: STEM-CPO-0906-ZJF)

The manufacturer of the 2465 Electrochemical Detector is Waters Corporation.
The Waters 2465 Electrochemical Detector combines sensitivity, reliability and simplicity for HPLC electrochemical detection. Its versatile detection modes are ideally suited for analyzing a wide range of compounds. The Waters 2465 Electrochemical Detector’s multiple flow-cell configuration combines working and reference electrode designs to minimize cost and enhance flexibility.

Condition: Pre-owned
Line frequency: 50 to 60 Hz
Line voltage: 100 to 240 VAC (self-selecting)
Operating modes: DC, Pulse, and Scan
Potential range: Between +2.00 and –2.00 V in 10-mV increments
Autozero: Triggered by keyboard, rear panel contact closure, or RS-232C control
RS-232C: Full control and data acquisition of all parameters
Detector oven: Height 37 cm, temperatures from 7 °C above ambient to 45 °C, accuracy 0.5 °C, stability 0.1 °C; accommodates HPLC column and flow cell
Rear panel I/O connections:
Main power
A (15-pin Sub D) – Input: Cell on, cell off, Start, Autozero, or Reset; Output: Relay 1, Relay 2, AUX 1, AUX 2, Overload
B (15-pin Sub D) – Inject marker (output) and Baseline marker (input)
C (phone jack) – Not applicable
OUTPUT (BNC) – Analog signal
RS-232C (9-pin Sub D) – Full instrument control; data acquisition
Ground stud – Instrument ground connector
Operating temperature range: 39 to 104 °F (4 to 40 °C)
Storage temperature range: –104 to 158 °F (–40 to 70 °C)
Relative humidity range: 20 to 80%, noncondensing
Storage humidity range: 0 to 90%, noncondensing
Spacers: 25, 50, or 120 µm
WE diameters: 2.00 and 2.74 mm (0.75 mm with micro flow cell)
Cell volume:
0.150 µL minimum with 3-mm flow cell
0.080 µL minimum with 2-mm (standard) flow cell
0.011 µL minimum with 0.75-mm (micro) flow cell
Working electrodes: Glassy carbon (GC), gold, platinum, and silver
Reference electrodes: Salt-bridge Ag/AgCl; ISAAC; Hy-REF
Auxiliary electrode: Stainless steel
Wetted materials: PCTFE, FEP, 316-SS (stainless steel), Viton®, silver, silver, chloride, gold, and platinum
Pressure: Maximum 40 psi (2.76 bar, 276 kPa)
Flow rate:
Standard flow cell: 25 µL/min to 2.0 mL/min
Micro flow cell: 1 to 25 µL/min

Refurbished to meet manufacturer's specification
In excellent condition
Thoroughly cleaned
Certified with warranty

Agilent 1100 Series Capillary Pump (G1376A), Agilent Technologies
Agilent 1260 Infinity Multiple Wavelength Detector MWD VL (G1365D), Agilent Technologies
Agilent 1260 Infinity II Fluorescence Detector FLD Spectra (G7121B), Agilent Technologies