General Purpose AFM Probes, HQ:NSC15/Cr-Au BS, 325 kHz (40 N/m), MikroMasch (CAT#: STEM-M-0070-LKN)

Cat Number: STEM-M-0070-LKN

Application: Cantilevers of the 15 series are generally used in tapping mode for imaging hard samples, when high topographic and phase contrast are necessary. The 15 series is also good for non-contact AFM.

Model: HQ:NSC15/Cr-Au BS

Add to Cart

Description Specification Features Related Products

Description

MikroMasch General Purpose AFM Probes are suitable for most of the routine topography imaging experiments. Using these probes, lateral resolution down to 5 nm is attainable for scan size below 1 μm. Usually, sharpened silicon etched probes are used for general purpose measurements.

Specification

Typical radius of uncoated tip: 8 nm
Full tip cone angle: 40°
Total tip height: 12 - 18 µm
Probe material: n-type silicon
Probe bulk resistivity: 0.01 - 0.025 Ohm*cm
Detector coating: Gold

Related Products

Long Scanning AFM Probes, HQ:NSC15/Hard/Al BS, 325 kHz (40 N/m), MikroMasch (CAT#: STEM-M-0071-LKN)
Conductive AFM Probes, HQ:NSC15/Cr-Au, 325 kHz (40 N/m), MikroMasch (CAT#: STEM-M-0072-LKN)

Other recommended products

Conductive AFM Probes, HQ:DPE-XSC11, 15 - 350 kHz (0.2 - 42 N/m), MikroMasch (CAT#: STEM-M-0141-LKN)
Highly Ordered Pyrolytic Graphite ZYH (HOPG, 3.5° Mosaic Spread), 10 x 10 x 2 mm, 5 chip, MikroMasch (CAT#: STEM-M-0163-LKN)
General Purpose AFM Probes, HQ:NSC36/Al BS, 65 - 130 kHz (0.6 - 2 N/m), MikroMasch (CAT#: STEM-M-0114-LKN)
Conductive AFM Probes, HQ:DPER-XSC11, 15 - 350 kHz (0.2 - 42 N/m), MikroMasch (CAT#: STEM-M-0142-LKN)
General Purpose AFM Probes, HQ:NSC36/Cr-Au BS, 65 - 130 kHz (0.6 - 2 N/m), MikroMasch (CAT#: STEM-M-0116-LKN)
General Purpose AFM Probes, HQ:NSC15/Al BS, 325 kHz (40 N/m), MikroMasch (CAT#: STEM-M-0068-LKN)
Silicon Nitride AFM Probes, XNC12/CR-AU BS, 17 - 67 kHz (0.08 - 0.32 N/m), MikroMasch (CAT#: STEM-M-0104-LKN)
Tipless AFM Probes, HQ:CSC37/tipless/Cr-Au, 20 - 40 kHz (0.3 - 0.8 N/m), MikroMasch (CAT#: STEM-M-0130-LKN)