General Purpose AFM Probes, HQ:NSC19/Al BS, 65 kHz (0.5 N/m), MikroMasch (CAT#: STEM-M-0086-LKN)

Cat Number: STEM-M-0086-LKN

Application: Cantilevers of the 19 series combine high resonance frequency and low spring constant, which makes them applicable to imaging soft and fragile surfaces at a relatively high speed in tapping mode. They are compatible with Bruker ScanAsyst ® PeakForce Tapping™*. The cantilevers may also be useful in LFM due to their high sensitivity to the lateral forces.

Model: HQ:NSC19/Al BS

Add to Cart

Description Specification Features Related Products

Description

MikroMasch General Purpose AFM Probes are suitable for most of the routine topography imaging experiments. Using these probes, lateral resolution down to 5 nm is attainable for scan size below 1 μm. Usually, sharpened silicon etched probes are used for general purpose measurements.

Specification

Typical radius of uncoated tip: 8 nm
Full tip cone angle: 40°
Total tip height: 12 - 18 µm
Probe material: n-type silicon
Probe bulk resistivity: 0.01 - 0.025 Ohm*cm
Detector coating: Aluminum

Related Products

General Purpose AFM Probes, HQ:NSC19/No Al, 65 kHz (0.5 N/m), MikroMasch (CAT#: STEM-M-0087-LKN)
Conductive AFM Probes, HQ:NSC19/Cr-Au, 65 kHz (0.5 N/m), MikroMasch (CAT#: STEM-M-0088-LKN)

Other recommended products

Long Scanning AFM Probes, HQ:NSC18/Hard/ Al BS, 75 kHz (2.8 N/m), MikroMasch (CAT#: STEM-M-0093-LKN)
Conductive AFM Probes, HQ:DPER-XSC11, 15 - 350 kHz (0.2 - 42 N/m), MikroMasch (CAT#: STEM-M-0142-LKN)
Highly Ordered Pyrolytic Graphite ZYH (HOPG, 3.5° Mosaic Spread), 10 x 10 x 1 mm, 5 chip, MikroMasch (CAT#: STEM-M-0162-LKN)
Magnetic AFM Probes, HQ:NSC36/Co-Cr/Al BS, 65 - 130 kHz (0.6 - 2 N/m), MikroMasch (CAT#: STEM-M-0120-LKN)
Magnetic AFM Probes, HQ:NSC18/Co-Cr/Al BS, 75 kHz (2.8 N/m), MikroMasch (CAT#: STEM-M-0096-LKN)
Conductive AFM Probes, HQ:NSC18/Pt, 75 kHz (2.8 N/m), MikroMasch (CAT#: STEM-M-0095-LKN)
Long Scanning AFM Probes, HQ:NSC14/Hard/Al BS, 160 kHz (5 N/m), MikroMasch (CAT#: STEM-M-0082-LKN)
General Purpose AFM Probes, HQ:NSC15/Al BS, 325 kHz (40 N/m), MikroMasch (CAT#: STEM-M-0068-LKN)